United Process Versapro Especificações descarregar pdf (Página 12)

VersaPro Temperature Controller Page 12

Figure 2 Wiring Schematic

4.1 Mounting

To mount the instrument in a control panel, a hole must be cut 3.62" square in the necessary location on the

panel. The following procedure should be followed to mount the VersaPro in the panel.

1) Insert the unit into previously cut out 3.62" square hole in panel.

2) While supporting unit, insert one clamping bracket into the groove on the bottom of unit, and then install

the 6-32 set screw.

3) Repeat step 2 for the top of the unit.

4) With a HEX KEY wrench, alternately tighten the screw on either side of instrument to a torque of six in.-

lbs. Insure rigidity of mounting. DO NOT OVER TIGHTEN. This can wrap the instrument enclosure

and make removal difficult.

To remove the instrument from the panel, reverse the above procedures.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 78 79

Sem comentários

United Process Versapro Especificações Página 12